Location: Albuquerque, NM 87110
Post Date: 12/19/2024
We are seeking a skilled tradesperson specializing in the cutting, installation, and repair of glass for various structures, including windows, doors, mirrors, and skylights. This position involves fitting glass into both commercial and residential buildings.
Compensation: Starting at $18.00 per hour
Schedule: Monday through Friday, 8:00 AM to 4:30 PM
Schedule: Monday through Friday, 8:00 AM to 4:30 PM
Key Responsibilities:
- Read and interpret measurements using a tape measure.
- Assist the lead setter with installing frames and replacing or installing custom glass.
- Operate power tools, ladders, scaffolding, and lifts safely and efficiently.
Requirements:
- Proficiency with power tools and construction equipment.
- Comfortable working at heights using ladders, scaffolding, and lifts.
- Clean driving record.
If you are detail-oriented, dependable, and eager to develop your skills in glass installation, we encourage you to apply!
Tools required:
- Steel toe boots/shoes
- Tool box – 24" or bucket boss
- 4ft. Level
- 2 ft. Level
- Tri-Square/ combination square
- 25'-35' Tape measure
- Hammer (framing/tack/claw)
- Rubber mallet/ dead blow hammer
- Utility knife
- Glaziers pouch (CRL)
- Scrape and pry bars (CRL)
- 5 in 1- 5 way- painters tool
- Flat putty knives 1"-3"
- Screwdriver set PH#1-3 Flat-same minimum
- Needle nose pliers
- Pliers
- Sheet metal sheers straight and angled
- 18v or better drill and impact driver set (optional to purchase through company)
- Standard and Metric Allen/hex head wrench sets
- 6" & 10" Crescent wrench
- Wire cutters (dikes-straight or offset)
- Blade snips (Rubber/plastic trim cutters)
- Vinyl roller (CRL)
- Impact nut driver sets 1/4-1/2"
- Cartridge caulking gun
Tools that are not Required but nice to have in addition to above list
- Torpedo level
- Speed square
- Framing square
- Chalk line/chalk
- Large pry bar (18-24")
- Channel locks
- Vise grips
- Standard/metric open/box end combo wrenches- basic sizing
- Standard/metric 1/4-3/8"
- Hack saw frame
- 12-24" Material clamps (2)
- File set for rasp and finish
- 1/4" Scratch Awl/ Punch
- Cold/wood chisel sets
- Step bits
- Nail sets
- Bags/pouches
- Cartridge caulking gun
#vipstaffing #zrnm
Job Interest
This job is already filled. If you would like us to send you information on jobs similar to this one you can do so by filling out the form below.
