Location: Albuquerque, NM 87113
Post Date: 01/09/2025
We are seeking a skilled tradesperson who specializes in cutting, installing, and repairing glass for various structures, including windows, doors, mirrors, and skylights. This position involves fitting glass into both commercial and residential buildings.
Compensation: Starting at $18.00 per hour
Schedule: Monday through Friday, 8:00 AM to 4:30 PM
Schedule: Monday through Friday, 8:00 AM to 4:30 PM
Key Responsibilities:
- Accurately read and interpret measurements using a tape measure.
- Support the lead installer in setting up frames and replacing or installing custom glass.
- Safely and effectively operate power tools, ladders, scaffolding, and lifts.
Requirements:
- Proficient in using power tools and construction equipment.
- Comfortable working at heights with ladders, scaffolding, and lifts.
- Possess a clean driving record.
If you are dependable, detail-oriented, and excited to grow your skills in glass installation, we invite you to apply!
Tools required:
- Steel toe boots/shoes
- Tool box – 24" or bucket boss
- 4ft. Level
- 2 ft. Level
- Tri-Square/ combination square
- 25'-35' Tape measure
- Hammer (framing/tack/claw)
- Rubber mallet/ dead blow hammer
- Utility knife
- Glaziers pouch (CRL)
- Scrape and pry bars (CRL)
- 5 in 1- 5 way- painters tool
- Flat putty knives 1"-3"
- Screwdriver set PH#1-3 Flat-same minimum
- Needle nose pliers
- Pliers
- Sheet metal sheers straight and angled
- 18v or better drill and impact driver set (optional to purchase through company)
- Standard and Metric Allen/hex head wrench sets
- 6" & 10" Crescent wrench
- Wire cutters (dikes-straight or offset)
- Blade snips (Rubber/plastic trim cutters)
- Vinyl roller (CRL)
- Impact nut driver sets 1/4-1/2"
- Cartridge caulking gun
Tools that are not Required but nice to have in addition to above list
- Torpedo level
- Speed square
- Framing square
- Chalk line/chalk
- Large pry bar (18-24")
- Channel locks
- Vise grips
- Standard/metric open/box end combo wrenches- basic sizing
- Standard/metric 1/4-3/8"
- Hack saw frame
- 12-24" Material clamps (2)
- File set for rasp and finish
- 1/4" Scratch Awl/ Punch
- Cold/wood chisel sets
- Step bits
- Nail sets
- Bags/pouches
- Cartridge caulking gun
#vipstaffing #zrnm
Job Interest
This job is already filled. If you would like us to send you information on jobs similar to this one you can do so by filling out the form below.
